Back-To-Back Frames Test Parameters (RFC
2544)
Test Duration
Frame Size
Traffic Load
Traffic Groups (Available when Enable Traffic Group Test is selected on the Select Test step.)
| Field |
Description |
Values |
Default |
| Duration Parameters |
| Min Duration |
Enabled when Trial Duration is set to Time
Duration of a trial in minutes
|
6.4E-05-5184000 |
6.4E-05 |
| Min Burst |
Enabled when Trial Duration is set to Bursts
Duration of a trial in frames
|
1-16777215 |
1 |
| Resolution (sec) |
Enter the smallest possible adjustment (in seconds) for the traffic load
from iteration to iteration. If the required adjustment to the current
load for the next iteration is less than the resolution, the test stops.
This parameter applies only if Trial Duration is set to
Seconds. |
N/A |
0.0001 |
| Resolution (frames) |
Enter the smallest possible adjustment (in frames) for the traffic
load from iteration to iteration. If the required adjustment to the current
load for the next iteration is less than the resolution, the test stops.
This parameter applies only if Trial Duration is set
to Bursts.
|
N/A |
100 |
| Acceptable Frame Loss |
Enter the maximum percentage of frames that may be lost during an iteration
without causing the iteration to fail. Frame loss is the aggregate loss
from all traffic flows, averaged across all ports included in the test.
CAUTION: This parameter must be 0 (zero)
to run RFC-compliant tests. |
|
0-100%
|
0% |
Related Information
RFC
2544 Test Package