Description:
Command to setup DCB queueput test.
Can be used with Command Sequencer: No
Parents: Sequencer
Children: DcbSetupTrafficGroupParams, DcbSetupTrafficGroupQueueputParams
Relations:
Side name (Type) |
Relative | Description |
---|---|---|
TestCaseConfig (BenchmarkingTestCaseConfig) |
Benchmarking test case config used to set up test command. |
|
SequencerRootCommand (TestCaseRootCommand) |
Parent command. |
Attribute | Description | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
Backoff |
Percentage of backoff. Type: double Default: 50.0 Range: 0.00001 - 100.0 |
||||||||||
BurstSizeList |
>Burst size values to use when iteration mode is CUSTOM. Type: u32 Default: 0 Range: 1 - 4294967295 |
||||||||||
Duration |
Duration. Type: u32 Default: 60 |
||||||||||
DurationInitial |
Initial duration. Type: double Default: 1 Range: 0.000064 - 4294967296.0 |
||||||||||
DurationLowerLimit |
Duration lower limit. Type: double Default: 1 Range: 0.000064 - 4294967296.0 |
||||||||||
DurationMode |
Duration mode. Type: enum Default: SECONDS Possible Values:
|
||||||||||
DurationStep |
Duration step. Type: double Default: 5 |
||||||||||
DurationUpperLimit |
Duration upper limit. Type: double Default: 120 Range: 0.000064 - 4294967296.0 |
||||||||||
FrameSizeList |
List of user-defined custom frame sizes. Type: u16 Default: 0 Range: 47 - 16383 |
||||||||||
LatencyMode |
Latency measurement mode. Type: enum Default: LILO Possible Values:
|
||||||||||
LoadSizeConfigMode |
Specifies which load configuration is to be used for this test case. Type: enum Default: WEIGHTED Possible Values:
|
||||||||||
LoadSizeList |
List of loads to use for CUSTOM iteration mode. Type: double Default: 0 Range: 0.000001 - 100000.0 |
||||||||||
LoadUnits |
Units used for the load value. Type: enum Default: PERCENT_LINE_RATE Possible Values:
|
||||||||||
NumOfTrials |
Number of trials to run. Type: u16 Default: 1 Range: 1 - 60 |
||||||||||
PfcPauseQueueConfigMode |
Indicates how the test should configure the hardware to respond to PFC frames from the DUT. Type: enum Default: MANUAL Possible Values:
|
||||||||||
PriorityFlowControlList |
List of priority flow controls. Type: u16 Default: 0 Range: 0 - 7 |
||||||||||
Resolution |
Search resolution. Type: double Default: 1 Range: 0.000064 - 4294967296.0 |
||||||||||
SearchMode |
Mode used to find the burst duration rate. Type: enum Default: BINARY Possible Values:
|
There are no read-only attributes.