OpenflowAddFlowsToSwitchCommand Object

HOME | TECHNOLOGIES | TEST CONFIGURATION | SEQUENCER COMMANDS | GUI COMMAND NAMES | ALL COMMANDS | RESULT | PDU | ALL | OBJECT TREE

Description:

Add flows to switches.

Can be used with Command Sequencer: Yes

GUI Command Name: Openflow: Add flows to switches

Parents: Sequencer, StcSystem

OpenflowAddFlowsToSwitchCommand Writable Attributes

Attribute Description
Common Writable Attributes ProgressCancelled
CalculateTiming

Whether timing measurements will be calculated for end-of-test results.

Type: bool

Default: FALSE

Possible Values:

Value Description
TRUE

Enable timing measurement calculations.
FALSE

Disable timing measurement calculations.
DelayAfterSwitchUpdateTime

Time in seconds to wait after the switch is done updating before retrieving timing measurements.

Type: double

Default: 0.0

Range: 0.0 - 2147483647.0
HandleList

Specify device list.

Type: handle

Default: 0
SwitchUpdateWaitTime

Maximum time in seconds to wait for the switch to finish updating.

Type: double

Default: 300.0

Range: 0.005 - 2147483647.0
TrafficAnalysis

Whether traffic analysis will be done.

Type: bool

Default: FALSE

Possible Values:

Value Description
TRUE

Enable traffic analysis. Observed Flow Add Setup Time and Observed Traffic Latency From Last Flow Add Time are reported in end-of-test results. End-of-test results use the last stream arrival time for stream blocks assigned to bound flow blocks for observed measurements.
FALSE

Disable traffic analysis.

OpenflowAddFlowsToSwitchCommand Read-Only Attributes

Read-Only Attribute Description
Common Read-Only Attributes ElapsedTime, EndTime, ProgressCurrentStep, ProgressCurrentStepName, ProgressCurrentValue, ProgressDisplayCounter, ProgressMaxValue, ProgressStepsCount, StartTime, State, Status