Description:
Sets up a data-plane convergence test for Routing Protocols. The Routing convergence test methodology is based on draft-ietf-bmwg-igp-dataplane-conv-meth-15.txt.
Can be used with Command Sequencer: Yes
GUI Command Name: Convergence: Setup Routing Convergence Command
| Attribute | Description | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Common Writable Attributes | ProgressCancelled | ||||||||||||
| EgressRouterList |
List of egress EmulatedDevice handles where traffic is expected to fall after convergence event. Type: handle Default: 0 |
||||||||||||
| IngressRouterList |
List of ingress EmulatedDevice (traffic initiators) handles in the test. Type: handle Default: 0 |
||||||||||||
| IpVersion |
IP version of the routing protocol and the streamblock traffic. Type: enum Default: IPV4 Possible Values:
|
||||||||||||
| MaxConvergenceTime |
The maximum time in the data-plane during which the DUT is expected to converge in. Type: u16 Default: 70 Range: 15 - 70 |
||||||||||||
| SecondaryEgressRouterList |
List of secondary egress EmulatedDevice handles where traffic is expected to increase after convergence event. Type: handle Default: 0 |
||||||||||||
| StreamBlockList |
List of streamblock handles for the test. Type: handle Default: 0 |
||||||||||||
| TestProtocol |
Routing Protocol for which convergence test should be performed. Type: enum Default: BGP Possible Values:
|
| Read-Only Attribute | Description |
|---|---|
| Common Read-Only Attributes | ElapsedTime, EndTime, ProgressCurrentStep, ProgressCurrentStepName, ProgressCurrentValue, ProgressDisplayCounter, ProgressMaxValue, ProgressStepsCount, StartTime, State, Status |