MldPortConfig Object

HOME | TECHNOLOGIES | TEST CONFIGURATION | SEQUENCER COMMANDS | GUI COMMAND NAMES | ALL COMMANDS | RESULT | PDU | ALL | OBJECT TREE

Description:

Creates/configures an MLD port.

Automatically created from: Port

Result children (automatically created): MldPortResults

Relations:

Side name
(Type)		 Relative Description
ResultChild
(ResultChild)

MldPortResults

Use this to connect a results object to an object.

MldPortConfig Writable Attributes

Attribute Description
Common Writable Attributes Active, Name
CalculateLatencyDelay

Specifies the delay (in seconds) before latency is calculated. The timer starts after reports are sent for each device. Note: Applies to interactive latency tests only.

Type: u32

Default: 10

Range: 1 - 3600
MaxBurst

Short-term maximum burst size in packets. A value of 0 specifies the maximum possible burst size.

Type: u32

Default: 0
RatePps

Long-term, maximum packet rate (in packets per second). A value of 0 specifies the maximum possible output rate.

Type: u32

Default: 0
VlanSubFilter

Specifies whether to filter on the Outer or Inner VLAN tag when calculating latency for devices with a PPPoE and stacked VLAN encapsulation.

Type: enum

Default: OUTER

Possible Values:

Value Description
OUTER

Specifies that the analyzer filter will be programmed to use the Outer VLAN ID.
INNER

Specifies that the analyzer filter will be programmed to use the Inner VLAN ID.

MldPortConfig Read-Only Attributes

There are no read-only attributes.