Ipv4VpnMcastNetworkBlock Object

HOME | TECHNOLOGIES | TEST CONFIGURATION | SEQUENCER COMMANDS | GUI COMMAND NAMES | ALL COMMANDS | RESULT | PDU | ALL | OBJECT TREE

Description:

Ipv4 Vpn Multicast Network Block for traffic receiver.

Parents: EmulatedDevice, ExternalDevice, ExternalDevicePort, Host, IptvChannelBlock, Port, Router, SUT

Children: GroupIf, SrEvpnSiteInfo, SrL3VpnSiteInfo

Relations:

Side name
(Type)		 Relative Description
DstBoundTo
(DstBinding)

PathDescriptor, StreamBlock

Specifies destination endpoints bound to StreamBlock.
EncapsulationSource
(Encapsulation)

PathDescriptor

Specifies the encapsulation.
MemberOfVpn
(MemberOfVpn)

EthernetVpnSiteInfo, VpnIdGroup, VpnSiteInfo6Pe, VpnSiteInfoMplsTpStatic, VpnSiteInfoRfc2547, VpnSiteInfoRfc4659, VpnSiteInfoVplsBgp, VpnSiteInfoVplsLdp

Do not use, to be removed
MulticastGroup
(MemberOfVpnMulticastGroup)

Ipv4Group, Ipv6Group

Relationship between Ipv4VpnMcastNetworkBlock and Ipv4Group.

MulticastExpectedRxPorts
(MulticastExpectedRxPorts)

Port

Traffic sent to this end point is expected to be received as multicast traffic by any of the ports connected through this relation.
OptionallyStackedUnder
(OptionallyStackedOnEndpoint)

Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf

Specifies an optionally-selected lower interface in the stack. Selection is controlled by protocol implementations which decide based on other criteria whether they should include the target interface in their stack.
SrcBoundTo
(SrcBinding)

PathDescriptor, StreamBlock

Specifies the source endpoint bound to StreamBlock.
StackedOn
(StackedOnEndpoint)

Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf

Specifies network endpoint stacking.
UnicastExpectedRxPorts
(UnicastExpectedRxPorts)

Port

Traffic sent to this end point is expected to be received as unicast traffic by any of the ports connected through this relation.
VpnTag
(VpnTag)

VpnTag

NetworkBlockVpnTag

Ipv4VpnMcastNetworkBlock Writable Attributes

Attribute Description
Common Writable Attributes Active, Name
AddrIncrement

Network address increment.

Type: u32

Default: 1
AddrIncrementPerRouter

NOTE: This attribute is deprecated. It will be removed in subsequent releases, so it is recommended that you do not use it.

Network address increment per router.

Type: u32

Default: 0
AddrModifierTypePerDevice

Address Modifier Type per Device in Device Block

Type: enum

Default: CONTINUOUS

Possible Values:

Value Description
CONTINUOUS

Address Modifier Type per Device in Device Block is Continuous
REPEAT

Address Modifier Type per Device in Device Block is Repeat
BindingMode

MVPN bound traffic binding mode.

Type: enum

Default: SELECTIVE_SOURCE_GROUP

Possible Values:

Value Description
SELECTIVE_SOURCE_GROUP

Use source address, group address, receiver router address and sender router distinguisher as traffic resolving key in selective mode.

SELECTIVE_ANY_SOURCE

Use group address, receiver router address and sender router distinguisher as traffic resolving key in selective mode.

SELECTIVE_ANY_GROUP

Use source address, receiver router address and sender router distinguisher as traffic resolving key in selective mode.

SELECTIVE_ANY_SOURCE_ANY_GROUP

Use receiver router address and sender router distinguisher as traffic resolving key in selective mode.

INCLUSIVE

Use receiver router address and receiver router distinguisher as traffic resolving key in inclusive mode.

NetworkCount

Number of networks.

Type: u32

Default: 1
NetworkInterfaceWithIpList

Create Network Interface for Network Block IP List

Type: bool

Default: FALSE

Possible Values:

Value Description
TRUE

Create Network Interface for Network Block IP List
FALSE

Disable Network Interface for Network Block IP List
PrefixLength

IPv4 address prefix length.

Type: u8

Default: 24

Range: 0 - 32
StartIpList

Start IPv4 address list.

Type: ip

Default: 192.0.1.0
UseUniqueIpForOverlappingPrefixes

Use Unique IP for Overlapping Prefixes

Type: bool

Default: FALSE

Possible Values:

Value Description
TRUE

Enable Use Unique IP for Overlapping Prefixes option

FALSE

Disable Use Unique IP for Overlapping Prefixes option

Ipv4VpnMcastNetworkBlock Read-Only Attributes

There are no read-only attributes.