PppoxServerIpv6PeerPool Object

HOME | TECHNOLOGIES | TEST CONFIGURATION | SEQUENCER COMMANDS | GUI COMMAND NAMES | ALL COMMANDS | RESULT | PDU | ALL | OBJECT TREE

Description:

PPPoX server IPv6 address pool.

Parents: EmulatedDevice, ExternalDevice, ExternalDevicePort, Host, IptvChannelBlock, Port, PppoaServerBlockConfig, PppoeServerBlockConfig, PppoL2tpv2ServerBlockConfig, PppoL2tpv3ServerBlockConfig, Router, SUT

Children: GroupIf, SrEvpnSiteInfo, SrL3VpnSiteInfo

Relations:

Side name
(Type)		 Relative Description
DstBoundTo
(DstBinding)

PathDescriptor, StreamBlock

Specifies destination endpoints bound to StreamBlock.
EncapsulationSource
(Encapsulation)

PathDescriptor

Specifies the encapsulation.
MemberOfVpn
(MemberOfVpn)

EthernetVpnSiteInfo, VpnIdGroup, VpnSiteInfo6Pe, VpnSiteInfoMplsTpStatic, VpnSiteInfoRfc2547, VpnSiteInfoRfc4659, VpnSiteInfoVplsBgp, VpnSiteInfoVplsLdp

Do not use, to be removed
MulticastExpectedRxPorts
(MulticastExpectedRxPorts)

Port

Traffic sent to this end point is expected to be received as multicast traffic by any of the ports connected through this relation.
OptionallyStackedUnder
(OptionallyStackedOnEndpoint)

Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf

Specifies an optionally-selected lower interface in the stack. Selection is controlled by protocol implementations which decide based on other criteria whether they should include the target interface in their stack.
SrcBoundTo
(SrcBinding)

PathDescriptor, StreamBlock

Specifies the source endpoint bound to StreamBlock.
StackedOn
(StackedOnEndpoint)

Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf

Specifies network endpoint stacking.
UnicastExpectedRxPorts
(UnicastExpectedRxPorts)

Port

Traffic sent to this end point is expected to be received as unicast traffic by any of the ports connected through this relation.
VpnTag
(VpnTag)

VpnTag

PppoxServerIpv6PeerPool Writable Attributes

Attribute Description
Common Writable Attributes Active, Name
AddrIncrement

Currently not used.

Type: u32

Default: 1
AddrIncrementPerRouter

NOTE: This attribute is deprecated. It will be removed in subsequent releases, so it is recommended that you do not use it.

IP address increment per router.

Type: u32

Default: 0
AddrModifierTypePerDevice

Address modifier type per device in device block.

Type: enum

Default: CONTINUOUS

Possible Values:

Value Description
CONTINUOUS

Continuous.
REPEAT

Repeat.
Ipv6IntfId

IPv6 address pool Interface ID (lower 64 bits) start.

Type: ipv6

Default: ::2
Ipv6IntfIdStep

IPv6 address pool Interface ID (lower 64 bits) step.

Type: ipv6

Default: ::1
Ipv6PeerPoolPrefix

IPv6 address pool prefix (upper 64 bits) start.

Type: ipv6

Default: 2001::
Ipv6PeerPoolPrefixStep

IPv6 address pool prefix (upper 64 bits) step.

Type: ipv6

Default: 0:0:0:1::
NetworkCount

Number of IPv6 addresses (prefixes and interface identifiers) in the pool.

Type: u32

Default: 1
NetworkInterfaceWithIpList

Flag indicating how to create Network Interface.

Type: bool

Default: FALSE

Possible Values:

Value Description
TRUE

Create one single Network Interface with multi IP addresses.
FALSE

Create multi Network Interface with multi IP addresses.
PrefixLength

Currently not used.

Type: u8

Default: 64

Range: 0 - 128
StartIpList

List of resolved session IPv6 addresses.

Type: ipv6

Default: 2000::1
UseUniqueIpForOverlappingPrefixes

Use Unique IP for Overlapping Prefixes

Type: bool

Default: FALSE

Possible Values:

Value Description
TRUE

Enable Use Unique IP for Overlapping Prefixes option

FALSE

Disable Use Unique IP for Overlapping Prefixes option

PppoxServerIpv6PeerPool Read-Only Attributes

There are no read-only attributes.