VbrasIf Object

GroupIf

PathDescriptor, StreamBlock, TrafficDescriptor

Specifies destination endpoints bound to StreamBlock.

PathDescriptor

Specifies the encapsulation.

CustomLink, CustomLink, DualStackLiteLink, DualStackLiteLink, EoamLink, EoamLink, EthernetBridgeLink, EthernetBridgeLink, EvpnCeToPeLink, EvpnCeToPeLink, IpForwardingLink, IpForwardingLink, Ipv6RapidDeploymentLink, Ipv6RapidDeploymentLink, ItagServiceLink, ItagServiceLink, L2GreTunnelLink, L2GreTunnelLink, L2tpv3ForwardingLink, L2tpv3ForwardingLink, MplsForwardingLink, MplsForwardingLink, MplsHierarchicalLink, MplsHierarchicalLink, MplsIpv4VpnCeToPeLink, MplsIpv4VpnCeToPeLink, MplsIpv6VpnCeToPeLink, MplsIpv6VpnCeToPeLink, MplsL2VpnPeToPLink, MplsL2VpnPeToPLink, MplsL3VpnPeToPLink, MplsL3VpnPeToPLink, MVpnGreCeToPeLink, MVpnGreCeToPeLink, MVpnGrePeToPLink, MVpnGrePeToPLink, OtvEdgeDeviceLink, OtvEdgeDeviceLink, StationToScompLink, StationToScompLink, VifToVicLink, VifToVicLink, VlanSwitchLink, VlanSwitchLink, VplsBgpCeToPeLink, VplsBgpCeToPeLink, VplsLdpCeToPeLink, VplsLdpCeToPeLink, VsiToStationLink, VsiToStationLink, VxlanGpeLink, VxlanGpeLink, VxlanVmToVtepLink, VxlanVmToVtepLink

EthernetVpnSiteInfo, VpnIdGroup, VpnSiteInfo6Pe, VpnSiteInfoMplsTpStatic, VpnSiteInfoRfc2547, VpnSiteInfoRfc4659, VpnSiteInfoVplsBgp, VpnSiteInfoVplsLdp

Do not use, to be removed

Port

Traffic sent to this end point is expected to be received as multicast traffic by any of the ports connected through this relation.

Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf

Specifies an optionally-selected lower interface in the stack. Selection is controlled by protocol implementations which decide based on other criteria whether they should include the target interface in their stack.

OtvEdgeDeviceConfig

EmulatedDevice, ExternalDevice, ExternalDevicePort, Host, Port, Router, SUT

Specifies if a top-level interface is facing the DUT.

Dhcpv4BlockConfig, Dhcpv4BlockConfig

BgpRouterConfig, IsisRouterConfig, LdpRouterConfig, LispRouterConfig, Ospfv2RouterConfig, Ospfv3RouterConfig, RsvpIngressTunnelParams, RsvpRouterConfig

Use this to link the traffic binding interfaces and traffic binding resolver.

PathDescriptor, StreamBlock, TrafficDescriptor

Specifies the source endpoint bound to StreamBlock.

Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf

Specifies network endpoint stacking.

EmulatedDevice, ExternalDevice, ExternalDevicePort, Host, Port, Router, SUT

Specifies the top-level interface in the interface stack.

L2tpv2BlockConfig

Port

Traffic sent to this end point is expected to be received as unicast traffic by any of the ports connected through this relation.

AncpAccessNodeConfig, AppPerfClientConfig, AppPerfServerConfig, AutosarTimeSyncConfig, BfdRouterConfig, BridgePortConfig, CifsClientProtocolConfig, CifsServerProtocolConfig, CoapServerConfig, CuspProtocolConfig, Dhcpv4BlockConfig, Dhcpv4ServerConfig, Dhcpv6BlockConfig, Dhcpv6PdBlockConfig, Dhcpv6ServerConfig, Dot1xSupplicantBlockConfig, DpgClientProtocolConfig, DpgServerProtocolConfig, DualStackLiteConfig, EcpriProtocolConfig, EoamNodeConfig, FcEPortConfig, FcFPortConfig, FcHostConfig, FcoeHostConfig, FcoeVePortConfig, FcoeVfPortConfig, FtpClientProtocolConfig, FtpServerProtocolConfig, HttpClientProtocolConfig, HttpServerProtocolConfig, Ieee1588v2ClockConfig, Ieee80211AccessPointConfig, Ieee80211ClientConfig, Ieee8021asClockConfig, IgmpHostConfig, IgmpRouterConfig, IperfClientProtocolConfig, IperfServerProtocolConfig, Ipv6RapidDeploymentConfig, L2tpv2BlockConfig, L2tpv3BlockConfig, LacpPortConfig, LagBfdPortConfig, LinkOamRouterConfig, LispRouterConfig, LldpNodeConfig, LspPingProtocolConfig, MacsecSupplicantBlockConfig, MldHostConfig, MldRouterConfig, MplsTpConfig, MplsTpOamNodeConfig, MsdpProtocolConfig, NetconfClientConfig, NetconfProtocolConfig, NtpClientConfig, OamFlexeClientConfig, OpenflowControllerProtocolConfig, OpflexDeviceConfig, OseSwitchConfig, Ospfv2RouterConfig, Ospfv3RouterConfig, OtvEdgeDeviceConfig, OtvSiteDeviceConfig, OvsdbServerConfig, PacketChannel, PcepProtocolConfig, PimRouterConfig, PppoaClientBlockConfig, PppoaServerBlockConfig, PppoeClientBlockConfig, PppoeServerBlockConfig, PppoL2tpv2ClientBlockConfig, PppoL2tpv2ServerBlockConfig, PppoL2tpv3ClientBlockConfig, PppoL2tpv3ServerBlockConfig, PppProtocolConfig, RawTcpClientProtocolConfig, RawTcpServerProtocolConfig, RipRouterConfig, RoEBlockConfig, SaaDeviceConfig, SipUaProtocolConfig, SrpConfig, Srv6OamProtocolConfig, StorageWorkerConfig, SyncEthDeviceConfig, TrillRbridgeConfig, TwampClientConfig, TwampServerConfig, VdpStationConfig, VicAdapterConfig, VideoClientProtocolConfig, VideoServerProtocolConfig, VifConfig, VsiBlockConfig, VxlanVtepConfig, XmppvJClientConfig

Specifies the interfaces used by the configuration object (configuration object examples: BgpRouterConfig, LdpRouterConfig, and so on).

Interface count.

Type: u32

Default: 1

Interface recycle count.

Type: u32

Default: 0

Loopback interface.

Type: bool

Default: FALSE

Possible Values:

Is block a range or table.

Type: bool

Default: TRUE

Possible Values:

The number of logical port per slot in the UP.

Type: u16

Default: 1

Range: 1 - 65535

Indicate the logic port of the UP.

Type: u16

Default: 0

The number of port per subcard in the UP.

Type: u8

Default: 1

Indicate the port of the UP.

Type: u8

Default: 0

The interface type of port in the UP.

Type: enum

Default: GE_10

Possible Values:

Indicate the protocol type of the vBRAS.

Type: enum

Default: ETHERNET

Possible Values:

The number of slot in the UP.

Type: u8

Default: 1

Range: 1 - 255

Indicate the Slot of the UP.

Type: u8

Default: 0

Indicate whether it is a static subscriber or not.

Type: bool

Default: FALSE

Possible Values:

The number of subslot per slot in the UP.

Type: u8

Default: 1

Range: 1 - 255

Indicate the subslot of the UP.

Type: u8

Default: 0

The number of VRF in the UP.

Type: u16

Default: 1

Range: 1 - 65535

Indicate the VRF of the UP.

Type: u16

Default: 0

Effective block count.

Type: u32

Default: 1

Interface state.

Type: enum

Default: DISABLED

Possible Values: