MPLS interface object.
Side name
(Type) |
Relative |
Description |
GroupIf (AffiliatedGroupIf) |
GroupIf
|
Affiliated group interface.
|
DstBoundTo (DstBinding) |
PathDescriptor, StreamBlock, TrafficDescriptor
|
Specifies destination endpoints bound to StreamBlock.
|
EncapsulationSource (Encapsulation) |
PathDescriptor
|
Specifies the encapsulation.
|
NetworkLink (LinkSrc) |
CustomLink, CustomLink, DualStackLiteLink, DualStackLiteLink, EoamLink, EoamLink, EthernetBridgeLink, EthernetBridgeLink, EvpnCeToPeLink, EvpnCeToPeLink, IpForwardingLink, IpForwardingLink, Ipv6RapidDeploymentLink, Ipv6RapidDeploymentLink, ItagServiceLink, ItagServiceLink, L2GreTunnelLink, L2GreTunnelLink, L2tpv3ForwardingLink, L2tpv3ForwardingLink, MplsForwardingLink, MplsForwardingLink, MplsHierarchicalLink, MplsHierarchicalLink, MplsIpv4VpnCeToPeLink, MplsIpv4VpnCeToPeLink, MplsIpv6VpnCeToPeLink, MplsIpv6VpnCeToPeLink, MplsL2VpnPeToPLink, MplsL2VpnPeToPLink, MplsL3VpnPeToPLink, MplsL3VpnPeToPLink, MVpnGreCeToPeLink, MVpnGreCeToPeLink, MVpnGrePeToPLink, MVpnGrePeToPLink, OtvEdgeDeviceLink, OtvEdgeDeviceLink, StationToScompLink, StationToScompLink, VifToVicLink, VifToVicLink, VlanSwitchLink, VlanSwitchLink, VplsBgpCeToPeLink, VplsBgpCeToPeLink, VplsLdpCeToPeLink, VplsLdpCeToPeLink, VsiToStationLink, VsiToStationLink, VxlanGpeLink, VxlanGpeLink, VxlanVmToVtepLink, VxlanVmToVtepLink
|
Link source.
|
MemberOfVpn (MemberOfVpn) |
EthernetVpnSiteInfo, VpnIdGroup, VpnSiteInfo6Pe, VpnSiteInfoMplsTpStatic, VpnSiteInfoRfc2547, VpnSiteInfoRfc4659, VpnSiteInfoVplsBgp, VpnSiteInfoVplsLdp
|
Do not use, to be removed
|
MulticastExpectedRxPorts (MulticastExpectedRxPorts) |
Port
|
Traffic sent to this end point is expected to be received as multicast traffic by
any of the ports connected through this relation.
|
OptionallyStackedUnder (OptionallyStackedOnEndpoint) |
Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf
|
Specifies an optionally-selected lower interface in the stack. Selection is
controlled by protocol implementations which decide based on other criteria whether they
should include the target interface in their stack.
|
OtvEdgeDeviceConfig (OtvTopLevelIf) |
OtvEdgeDeviceConfig
|
Otv top level private interface.
|
PrimaryIfSource (PrimaryIf) |
EmulatedDevice, ExternalDevice, ExternalDevicePort, Host, Port, Router, SUT
|
Specifies if a top-level interface is facing the DUT.
|
RelayBlockConfig (RelayIf) |
Dhcpv4BlockConfig, Dhcpv4BlockConfig
|
Config to relay agent interface.
|
(ResolvesInterface) |
BgpRouterConfig, IsisRouterConfig, LdpRouterConfig, LispRouterConfig, Ospfv2RouterConfig, Ospfv3RouterConfig, RsvpIngressTunnelParams, RsvpRouterConfig
|
Use this to link the traffic binding interfaces and traffic binding
resolver.
|
SrcBoundTo (SrcBinding) |
PathDescriptor, StreamBlock, TrafficDescriptor
|
Specifies the source endpoint bound to StreamBlock.
|
StackedOn (StackedOnEndpoint) |
Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf
|
Specifies network endpoint stacking.
|
TopLevelIfSource (TopLevelIf) |
EmulatedDevice, ExternalDevice, ExternalDevicePort, Host, Port, Router, SUT
|
Specifies the top-level interface in the interface stack.
|
L2tpv2UdpConfig (UdpSrcCustomIf) |
L2tpv2BlockConfig
|
Config to Udp source custom interface.
|
UnicastExpectedRxPorts (UnicastExpectedRxPorts) |
Port
|
Traffic sent to this end point is expected to be received as unicast traffic by any
of the ports connected through this relation.
|
UsesIfSource (UsesIf) |
AncpAccessNodeConfig, AppPerfClientConfig, AppPerfServerConfig, AutosarTimeSyncConfig, BfdRouterConfig, BridgePortConfig, CifsClientProtocolConfig, CifsServerProtocolConfig, CoapServerConfig, CuspProtocolConfig, Dhcpv4BlockConfig, Dhcpv4ServerConfig, Dhcpv6BlockConfig, Dhcpv6PdBlockConfig, Dhcpv6ServerConfig, Dot1xSupplicantBlockConfig, DpgClientProtocolConfig, DpgServerProtocolConfig, DualStackLiteConfig, EcpriProtocolConfig, EoamNodeConfig, FcEPortConfig, FcFPortConfig, FcHostConfig, FcoeHostConfig, FcoeVePortConfig, FcoeVfPortConfig, FtpClientProtocolConfig, FtpServerProtocolConfig, HttpClientProtocolConfig, HttpServerProtocolConfig, Ieee1588v2ClockConfig, Ieee80211AccessPointConfig, Ieee80211ClientConfig, Ieee8021asClockConfig, IgmpHostConfig, IgmpRouterConfig, IperfClientProtocolConfig, IperfServerProtocolConfig, Ipv6RapidDeploymentConfig, L2tpv2BlockConfig, L2tpv3BlockConfig, LacpPortConfig, LagBfdPortConfig, LinkOamRouterConfig, LispRouterConfig, LldpNodeConfig, LspPingProtocolConfig, MacsecSupplicantBlockConfig, MldHostConfig, MldRouterConfig, MplsTpConfig, MplsTpOamNodeConfig, MsdpProtocolConfig, NetconfClientConfig, NetconfProtocolConfig, NtpClientConfig, OamFlexeClientConfig, OpenflowControllerProtocolConfig, OpflexDeviceConfig, OseSwitchConfig, Ospfv2RouterConfig, Ospfv3RouterConfig, OtvEdgeDeviceConfig, OtvSiteDeviceConfig, OvsdbServerConfig, PacketChannel, PcepProtocolConfig, PimRouterConfig, PppoaClientBlockConfig, PppoaServerBlockConfig, PppoeClientBlockConfig, PppoeServerBlockConfig, PppoL2tpv2ClientBlockConfig, PppoL2tpv2ServerBlockConfig, PppoL2tpv3ClientBlockConfig, PppoL2tpv3ServerBlockConfig, PppProtocolConfig, RawTcpClientProtocolConfig, RawTcpServerProtocolConfig, RipRouterConfig, RoEBlockConfig, SaaDeviceConfig, SipUaProtocolConfig, SrpConfig, Srv6OamProtocolConfig, StorageWorkerConfig, SyncEthDeviceConfig, TrillRbridgeConfig, TwampClientConfig, TwampServerConfig, VdpStationConfig, VicAdapterConfig, VideoClientProtocolConfig, VideoServerProtocolConfig, VifConfig, VsiBlockConfig, VxlanVtepConfig, XmppvJClientConfig
|
Specifies the interfaces used by the configuration object (configuration object
examples: BgpRouterConfig, LdpRouterConfig, and so on).
|
Attribute |
Description |
Common Writable Attributes
|
Active, Name
|
DstMac
|
Resolved destination MAC.
Type: mac
Default: 00:00:01:00:00:01
|
ExperimentalBits
|
MPLS label experimental bits.
Type: u8
Default: 0
Range: 0 - 7
|
IfCountPerLowerIf
|
Number of interfaces in this interface object.
Type: u32
Default: 1
|
IfRecycleCount
|
How many to times to increment the MPLS label before returning to the
starting value. See Label for more information.
Type: u32
Default: 0
|
IsLoopbackIf
|
Whether this is a loopback interface.
Type: bool
Default: FALSE
Possible Values:
Value |
Description |
TRUE |
This is a loopback interface.
|
FALSE |
This is not a loopback interface.
|
|
IsRange
|
Whether to use a combination of attributes to generate a range of MPLS
labels, or to use the LabelList attribute to specify the MPLS labels.
Type: bool
Default: TRUE
Possible Values:
Value |
Description |
TRUE |
Use a combination of attributes to generate a range of MPLS labels.
The attributes are Label, LabelStep, LabelRepeatCount, and IfRecycleCount.
See Label for more information.
|
FALSE |
Use the LabelList attribute to specify the MPLS
labels.
|
|
Label
|
MPLS label. You can generate more than one MPLS label by using
LabelRepeatCount, LabelStep, and IfRecycleCount. If you do that, then the value of
this attribute is the starting MPLS label.
To use this attribute, the IsRange attribute must be TRUE.
Example: Label = 1, LabelStep = 1, IfRecycleCount = 2, LabelRepeatCount = 0.
Generated values will be 1, 2, 1, 2, 1, 2, and so on.
Example: Label = 1, LabelStep = 1, IfRecycleCount = 2, LabelRepeatCount = 1.
Generated values will be 1, 1, 2, 2, 1, 1, 2, 2, 1, 1, 2, 2, and so
on.
Type: u32
Default: 1
Range: 0 - 1048575
|
LabelList
|
A Tcl list of MPLS labels. To use this attribute, the IsRange attribute
must be FALSE.
Type: u32
Default: 0
|
LabelRepeatCount
|
How many times to repeat the same MPLS Label before incrementing it. See
Label for more information.
Type: u16
Default: 0
|
LabelResolver
|
Label resolver identifier.
Type: string
Default: default
|
LabelStep
|
MPLS label step value. See Label for more information.
Type: s32
Default: 1
|
StackBit
|
MPLS end-of-stack bit.
Type: u8
Default: 0
Range: 0 - 1
|
TTL
|
MPLS TTL value.
Type: u8
Default: 0
Range: 0 - 255
|