EthIIIf Object

GroupIf

Affiliated group interface.

Ethernet100GigFiber, Ethernet10GigCopper, Ethernet10GigFiber, Ethernet200GigFiber, Ethernet25GigFiber, Ethernet400GigFiber, Ethernet40GigFiber, Ethernet50GigFiber, Ethernet800GigFiber, EthernetCopper, EthernetFiber, EthernetPoECopper, Ieee80211Phy

Specifies physical layer compatibility

PathDescriptor, StreamBlock, TrafficDescriptor

Specifies destination endpoints bound to StreamBlock.

PathDescriptor

Specifies the encapsulation.

CustomLink, CustomLink, DualStackLiteLink, DualStackLiteLink, EoamLink, EoamLink, EthernetBridgeLink, EthernetBridgeLink, EvpnCeToPeLink, EvpnCeToPeLink, IpForwardingLink, IpForwardingLink, Ipv6RapidDeploymentLink, Ipv6RapidDeploymentLink, ItagServiceLink, ItagServiceLink, L2GreTunnelLink, L2GreTunnelLink, L2tpv3ForwardingLink, L2tpv3ForwardingLink, MplsForwardingLink, MplsForwardingLink, MplsHierarchicalLink, MplsHierarchicalLink, MplsIpv4VpnCeToPeLink, MplsIpv4VpnCeToPeLink, MplsIpv6VpnCeToPeLink, MplsIpv6VpnCeToPeLink, MplsL2VpnPeToPLink, MplsL2VpnPeToPLink, MplsL3VpnPeToPLink, MplsL3VpnPeToPLink, MVpnGreCeToPeLink, MVpnGreCeToPeLink, MVpnGrePeToPLink, MVpnGrePeToPLink, OtvEdgeDeviceLink, OtvEdgeDeviceLink, StationToScompLink, StationToScompLink, VifToVicLink, VifToVicLink, VlanSwitchLink, VlanSwitchLink, VplsBgpCeToPeLink, VplsBgpCeToPeLink, VplsLdpCeToPeLink, VplsLdpCeToPeLink, VsiToStationLink, VsiToStationLink, VxlanGpeLink, VxlanGpeLink, VxlanVmToVtepLink, VxlanVmToVtepLink

Link source.

EthernetVpnSiteInfo, VpnIdGroup, VpnSiteInfo6Pe, VpnSiteInfoMplsTpStatic, VpnSiteInfoRfc2547, VpnSiteInfoRfc4659, VpnSiteInfoVplsBgp, VpnSiteInfoVplsLdp

Do not use, to be removed

Port

Traffic sent to this end point is expected to be received as multicast traffic by any of the ports connected through this relation.

Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf

Specifies an optionally-selected lower interface in the stack. Selection is controlled by protocol implementations which decide based on other criteria whether they should include the target interface in their stack.

OtvEdgeDeviceConfig

OTV top level private interface.

EmulatedDevice, ExternalDevice, ExternalDevicePort, Host, Port, Router, SUT

Specifies if a top-level interface is facing the DUT.

Dhcpv4BlockConfig, Dhcpv4BlockConfig

Config to relay agent interface.

BgpRouterConfig, IsisRouterConfig, LdpRouterConfig, LispRouterConfig, Ospfv2RouterConfig, Ospfv3RouterConfig, RsvpIngressTunnelParams, RsvpRouterConfig

Use this to link the traffic binding interfaces and traffic binding resolver.

PathDescriptor, StreamBlock, TrafficDescriptor

Specifies the source endpoint bound to StreamBlock.

Aal5If, Dhcpv4ServerDefaultPoolConfig, Dhcpv4ServerPoolConfig, Dhcpv6ServerAddrPoolConfig, Dhcpv6ServerDefaultAddrPoolConfig, Dhcpv6ServerDefaultPrefixPoolConfig, Dhcpv6ServerPrefixPoolConfig, EthIIIf, FcIf, GreIf, GroupIf, HdlcIf, Ipv4If, Ipv4NetworkBlock, Ipv4VpnMcastNetworkBlock, Ipv6If, Ipv6NetworkBlock, Ipv6SrhIf, Ipv6VpnMcastNetworkBlock, ItagIf, L2tpv2If, L2tpv3If, LispIf, MacBlock, MacsecIf, MplsIf, Pimv4JoinSrc, Pimv4PruneSrc, Pimv6JoinSrc, Pimv6PruneSrc, PppIf, PppoeIf, PppoeServerIpv4PeerPool, PppoxServerIpv4PeerPool, PppoxServerIpv6PeerPool, TrillIf, VbrasIf, VlanBlock, VlanIf, VxlanGpeIf, VxlanIf

Specifies network endpoint stacking.

EmulatedDevice, ExternalDevice, ExternalDevicePort, Host, Port, Router, SUT

Specifies the top-level interface in the interface stack.

L2tpv2BlockConfig

Config to Udp source custom interface.

Port

Traffic sent to this end point is expected to be received as unicast traffic by any of the ports connected through this relation.

AncpAccessNodeConfig, AppPerfClientConfig, AppPerfServerConfig, AutosarTimeSyncConfig, BfdRouterConfig, BridgePortConfig, CifsClientProtocolConfig, CifsServerProtocolConfig, CoapServerConfig, CuspProtocolConfig, Dhcpv4BlockConfig, Dhcpv4ServerConfig, Dhcpv6BlockConfig, Dhcpv6PdBlockConfig, Dhcpv6ServerConfig, Dot1xSupplicantBlockConfig, DpgClientProtocolConfig, DpgServerProtocolConfig, DualStackLiteConfig, EcpriProtocolConfig, EoamNodeConfig, FcEPortConfig, FcFPortConfig, FcHostConfig, FcoeHostConfig, FcoeVePortConfig, FcoeVfPortConfig, FtpClientProtocolConfig, FtpServerProtocolConfig, HttpClientProtocolConfig, HttpServerProtocolConfig, Ieee1588v2ClockConfig, Ieee80211AccessPointConfig, Ieee80211ClientConfig, Ieee8021asClockConfig, IgmpHostConfig, IgmpRouterConfig, IperfClientProtocolConfig, IperfServerProtocolConfig, Ipv6RapidDeploymentConfig, L2tpv2BlockConfig, L2tpv3BlockConfig, LacpPortConfig, LagBfdPortConfig, LinkOamRouterConfig, LispRouterConfig, LldpNodeConfig, LspPingProtocolConfig, MacsecSupplicantBlockConfig, MldHostConfig, MldRouterConfig, MplsTpConfig, MplsTpOamNodeConfig, MsdpProtocolConfig, NetconfClientConfig, NetconfProtocolConfig, NtpClientConfig, OamFlexeClientConfig, OpenflowControllerProtocolConfig, OpflexDeviceConfig, OseSwitchConfig, Ospfv2RouterConfig, Ospfv3RouterConfig, OtvEdgeDeviceConfig, OtvSiteDeviceConfig, OvsdbServerConfig, PacketChannel, PcepProtocolConfig, PimRouterConfig, PppoaClientBlockConfig, PppoaServerBlockConfig, PppoeClientBlockConfig, PppoeServerBlockConfig, PppoL2tpv2ClientBlockConfig, PppoL2tpv2ServerBlockConfig, PppoL2tpv3ClientBlockConfig, PppoL2tpv3ServerBlockConfig, PppProtocolConfig, RawTcpClientProtocolConfig, RawTcpServerProtocolConfig, RipRouterConfig, RoEBlockConfig, SaaDeviceConfig, SipUaProtocolConfig, SrpConfig, Srv6OamProtocolConfig, StorageWorkerConfig, SyncEthDeviceConfig, TrillRbridgeConfig, TwampClientConfig, TwampServerConfig, VdpStationConfig, VicAdapterConfig, VideoClientProtocolConfig, VideoServerProtocolConfig, VifConfig, VsiBlockConfig, VxlanVtepConfig, XmppvJClientConfig

Specifies the interfaces used by the configuration object (configuration object examples: BgpRouterConfig, LdpRouterConfig, and so on).

Authenticator identifier string.

Type: string

Default: default

Number of interfaces in this interface object.

Type: u32

Default: 1

How many to times to increment the source MAC address before returning to the starting value. See SourceMac for more information.

Type: u32

Default: 0

Whether this is a loopback interface.

Type: bool

Default: FALSE

Possible Values:

Whether to use a combination of attributes to generate a range of source MAC addresses, or to use the SrcMacList attribute to specify the source MAC addresses.

Type: bool

Default: TRUE

Possible Values:

Source MAC address. You can generate more than one source MAC address by using combinations of SrcMacRepeatCount, SrcMacStep, SrcMacStepMask, and IfRecycleCount. If you do that, then this attribute is the starting source MAC address.

To use this attribute, the IsRange attribute must be TRUE.

Example: SourceMac = 00:10:94:00:00:02, SrcMacStep = 00:00:00:00:00:01, SrcMacStepMask = 00:00:FF:FF:FF:FF, IfRecycleCount = 2, SrcMacRepeatCount = 0. Generated values will be 00:10:94:00:00:02, 00:10:94:00:00:03, 00:10:94:00:00:02, 00:10:94:00:00:03, and so on.

Example: SourceMac = 00:10:94:00:00:02, SrcMacStep = 00:00:00:00:00:01, SrcMacStepMask = 00:00:FF:FF:FF:FF, IfRecycleCount = 2, SrcMacRepeatCount = 1. Generated values will be 00:10:94:00:00:02, 00:10:94:00:00:02, 00:10:94:00:00:03, 00:10:94:00:00:03, 00:10:94:00:00:02, 00:10:94:00:00:02, 00:10:94:00:00:03, 00:10:94:00:00:03, and so on.

Type: mac

Default: 00:10:94:00:00:02

A Tcl list of source MAC addresses. To use this attribute, the IsRange attribute must be FALSE.

Type: mac

Default: 0

How many times to repeat the same source MAC address before incrementing it. See SourceMac for more information.

Type: u32

Default: 0

Source MAC address step value. See SourceMac for more information.

Type: mac

Default: 00:00:00:00:00:01

Source MAC address step mask. Indicates which parts of the MAC address will change when incremented. See SourceMac for more information.

Type: mac

Default: 00:00:FF:FF:FF:FF

Use source MAC address from physical interface.

Type: bool

Default: FALSE

Possible Values:

Authentication state of this interface.

Type: enum

Default: RESOLVE_DONE

Possible Values:

Block count for this interface.

Type: u32

Default: 1

State of this interface.

Type: enum

Default: DISABLED

Possible Values: